Inspection Procedure

Fig 1: Identifying Terminal C9-9

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Remove the combination meter assy with connector still connected.
2. Check voltage.
   1. Jack up either of the front wheels.
   2. Shift the shift lever to neutral.
   3. Turn the ignition switch to ON.
   4. Measure the voltage between terminals C9-9 of combination meter assy and body ground when front wheel is turning slowly.
      VOLTAGE SIGNAL GRAPH RESULT
      
      

      A	B	C
      OK	NG (w/ ABS)	NG (w/o ABS)

      A: CHECK AND REPLACE COMBINATION METER ASSY 

      B: Go to next step 

      C: Go to step   3 

      Fig 2: Identifying Voltage Signal Graph

      Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check output value of skid control ECU.
   1. Connect the hand-held tester to DLC3.
   2. Turn the ignition switch to ON and push the hand-held tester main switch ON.
   3. Select the DATA LIST mode on the hand-held tester.
   4. Check that there is no difference between the speed value output from the speed sensor displayed by the hand-held tester and the speed value displayed by the speedometer when driving the vehicle.

OK: There is almost no difference from the displayed speed value. 

NG: GO TO BRAKE SYSTEM 

OK: REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 3: Identifying Speedometer Sensor Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Check voltage.
   1. Shift the shift lever to neutral.
   2. Jack up either of the front wheels.
   3. Turn the ignition switch to ON.
   4. Measure voltage between terminals 3 and 2 of speed sensor when the front wheel is turning slowly.

Standard voltage: Voltage is generated intermittently. 

Fig 4: Identifying Voltage Signal Graph

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: CHECK AND REPLACE SPEEDOMETER SENSOR 

OK: REPAIR OR REPLACE HARNESS OR CONNECTOR