Inspection Procedure

INSPECT FUEL SENDER GAGE ASSY

Fig 1: Identifying Fuel Sender Gauge Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disconnect the connector fuel sender gauge.

Check the float position between E and F and measure the resistance between terminals 2 and 3 of the connector. Check that the resistance value changes continuously.

RESISTANCE VALUE CHANGES CONTINUOUSLY CHECK

Float level	Float position mm (in.)	Resistance
F	64.5 (2.53) +/- 3 (0.12)	15.0 +/- 1
1/2	11.6 (0.45) +/---> 3 (0.12)	54.7 +/- 3
E	52.7 (2.07) --> 3 (0.12)	107.0 +/- 1

Fig 2: Identifying Fuel Sender Gage Float Level

NG: REPLACE FUEL SENDER GAGE ASSY

OK: GO TO next step

CHECK HARNESS AND CONNECTOR (BETWEEN FUEL SENDER GAGE AND COMBINATION METER ASSY)
NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: CHECK AND REPLACE COMBINATION METER ASSY