Inspection Procedure

1. Check that continuity exists of DOME fuse.
2. Check that continuity exists of GAUGE fuse.
3. Check that continuity exists of AM1 fuse.

NG: REPLACE FUSE 

OK: Go to next step. 

1. Check continuity.
   1. Disconnect the "C9" connector from combination meter assy.
   2. Check continuity between terminal C9-2 of combination meter assy connector and body ground.

      OK: Continuity exists 

   Fig 1: Identifying Terminal C9-2
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check voltage.
   1. Disconnect the "C9" connector from combination meter assy.
   2. Measure voltage between terminal C9-5 of combination meter assy connector and body ground.

      Voltage: 10 - 14 V 

   Fig 2: Identifying Terminals C9-4 & C9-5
   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   3. Turn the ignition switch to ON.
   4. Measure voltage between terminal C9-4 of combination meter assy connector and body ground.

      Voltage: 10 - 14 V 

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      OK: CHECK AND REPLACE COMBINATION METER ASSY