Parking Brake (Internal Shoe): Removal
- Raise and support vehicle.
- Remove rear wheel.
- Place alignment marks on the hub and disc for reinstallation reference. Release parking brake and remove the disc.
- Remove shoe return springs.
- Remove front shoe adjuster and tension spring:
- Disconnect the tension spring from the front shoe.
- Slide front shoe out and remove the shoe adjuster.
- Remove the shoe strut with the spring.
- Remove the shoe hold down spring, spring caps and pin.
- Remove rear shoe:
- Slide rear shoe out and remove the tension spring.
- Remove the shoe hold down spring, spring caps and pin.
- Use needle-nose pliers to disconnect the parking brake cable from the parking brake shoe lever.
NOTE:
If disk does not turn freely, turn the shoe adjuster until wheel turns freely.