Master Cylinder: Removal
- Remove air cleaner cover with air cleaner hose.
- Draw brake fluid from reservoir with a syringe.
- Disconnect level warning switch connector. See Figure.
- If equipped with vehicle skid control, disconnect reservoir hose.
- Disconnect brake lines:
- For vehicles without Vehicle Skid Control, Use a flare nut wrench to disconnect the 4 brakeline union nuts from the master cylinder and 2-way valve. See Figure.
- For vehicles with Vehicle Skid Control, Use a flare nut wrench to disconnect the 5 brakeline union nuts from the master cylinder and 3-way valve. See Figure.
- Remove the 2 master cylinder mounting nuts, remove the 2 or 3-way valve, master cylinder, and gasket.