Step 1 - Problem No. 1 (Clock Will Not Operate)

NOTE: Inspect the connector on the wire harness side.

Check that the battery positive voltage is 10 - 16 V.
If voltage is not as specified, replace the battery.

NOTE: For fuse location, see FUSES & CIRCUIT BREAKERS .

Check that the DOME fuse is not blown.
If the fuse is blown, replace the fuse and check for short.
Troubleshoot the clock as follows.

Fig 1: Identifying Connector A & B Terminals (Wire Harness Side)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Step 1 Troubleshooting Procedures
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002