Rear

REPLACEMENT
1. REMOVE REAR WHEEL
2. REMOVE BRAKE DRUM





3. REMOVE HUB BOLT
Using SST, 2 nuts and a screwdriver or an equivalent, remove the hub bolt.
SST 09628-10011





4. INSTALL HUB BOLT
a. Install a washer and nut to a new hub bolt as shown in the illustration.
b. Using a screwdriver or an equivalent to hold, install the hub bolt by torquing the nut.
c. Remove the 3 nuts and washer.
5. INSTALL BRAKE DRUM
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)