Condenser Fan Resistor: Testing and Inspection
CONDENSER FAN RESISTORINSPECTION
1. REMOVE ENGINE UNDER COVER LH
2. REMOVE CONDENSER FAN RESISTOR
a. Disconnect the connector.
b. Remove the 2 bolts and condenser fan resistor.
3. INSPECT CONDENSER FAN RESISTOR RESISTANCE
Measure resistance between terminals.
Standard resistance: 1.3 ± 0.13 ohm
If resistance is not as specified, replace the condenser fan resistor.
4. INSTALL CONDENSER FAN RESISTOR
a. Install the condenser fan resistor with 2 bolts.
b. Connect the connector.
5. INSTALL ENGINE UNDER COVER LH