Speed Sensor, Front

REMOVAL





1. DISCONNECT SPEED SENSOR CONNECTOR
Disconnect the speed sensor connector.
2. REMOVE FRONT WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)





3. REMOVE SPEED SENSOR
a. Remove the 2 clamp bolts and a clip holding the sensor harness to the body and shock absorber.
Torque:
Harness clamp x Body: 8.0 Nm (82 kgf-cm, 71 inch lbs.)
Harness clamp x Shock absorber: 29.0 Nm (300 kgf-cm, 22 ft. lbs.)
b. Remove the bolt and speed sensor from the steering knuckle.
Torque: 8.0 Nm (82 kgf-cm, 71 inch lbs.)

INSTALLATION
Installation is in the reverse order of removal.

HINT: After installation, check the speed sensor signal.