Upper Side Moulding / Trim: Service and Repair

ROOF DRIP SIDE FINISH MOULDING

Roof Drip Side Finish Moulding:

REMOVAL

REMOVE ROOF DRIP SIDE FINISH MOULDING
Using a moulding remover, remove the roof drip side finish moulding.

NOTE:
- Do not damage the body.
- When the clip comes off, replace it with a new one.

INSTALLATION

1. INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP
If the roof drip side finish moulding clip comes off.
a. Using a heat light, heat the body mounting surface to 40 - 60 °C (104 - 140 °F).

NOTE: Do not heat the body excessively.

b. Remove the adhesive tape and adhesive from the body.
c. Wipe off stains with cleaner.
d. Using a heat light, heat the body and clip.
Body: 40 - 60 °C (104 - 140 °F)
Clip: 20 - 30 °C (68 - 86 °F)

NOTE: Do not heat the body and clip excessively.

e. Install the clip.
f. Use the same manner described above to the other side (the front or rear side).

2. INSTALL ROOF DRIP SIDE FINISH MOULDING