Manual Shift Test
WARNING: This page is about a different car, the 2002 Toyota ECHO, 2002 Toyota Celica, 2001 Toyota ECHO, and 2001 Toyota Celica. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform manual shift test if no DTCs are stored. Manual shift test determines if problem is in electrical circuits or is a mechanical transaxle problem.
Ensure ignition switch is in OFF position. Disconnect 10-pin transaxle connector, located above PNP switch on transaxle. Road test vehicle and ensure transaxle gear changes correspond with selector lever position. See GEAR APPLICATION table. If abnormality exists, a mechanical transaxle problem may exist. Turn ignition switch to the OFF position. Reconnect transaxle connector. Disconnecting transaxle connector may set DTC. Clear DTCs from ECM memory. See CLEARING DIAGNOSTIC TROUBLE CODES under SELF-DIAGNOSTIC SYSTEM.
GEAR APPLICATION
| Selector Lever Position | Gear |
|---|---|
| "D" | Overdrive |
| "2" | Overdrive |
| "L" | 1st |
| "R" | Reverse |
| "P" | Park |