H2-H4 Shift (Center Differential Lock "Free" Shift)
WARNING: This page is about a different variant/trim than selected.
NOTE:
For circuit reference, see CONNECTOR IDENTIFICATION and/or WIRING DIAGRAMS
.
- Turn the ignition ON and shift the transfer shift lever to the "H" position.
- Check that the 4WD indicator comes ON when the 2-4 selector is pressed ON. Check that the 4WD indicator goes OFF when the switch is pressed OFF.
- If the light does not light up, even though the switch has been turned ON, the vehicle should be moved back and forth. If switching is not completed after 3 seconds of shift operation, the H4 indicator light will flash.