LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2002 >> 4Runner Limited, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Transfer Case (Diagnosis) (VF3AM)) >> Component Tests >> Automatic Disconnect Differential Actuator

Automatic Disconnect Differential Actuator

WARNING: This page is about a different variant/trim than selected.
NOTE: For circuit reference, see CONNECTOR IDENTIFICATION  and/or WIRING DIAGRAMS  .
  1. Disconnect actuator connector. Measure resistance between terminal Nos. 2 and 6. See Figure. Resistance should be 0.3-100 ohms. Measure resistance between terminal Nos. 2 and 6 and ground. Resistance should be more than 0.5 ohms. If resistance value is not as specified, replace actuator assembly.
  2. Apply battery positive voltage to actuator terminal No. 2 and ground actuator terminal No. 6. See Figure. Listen for actuator engagement operation. Using an ohmmeter, check for continuity between actuator terminal Nos. 3 and 4. If there is no continuity, replace actuator.
  3. Apply battery positive voltage to actuator terminal No. 6 and ground actuator terminal No. 2. Listen for actuator disengagement operation. Using an ohmmeter, check that there is no continuity between actuator terminals No. 3 and 4. If there is continuity, replace actuator.
scientia non olet · About LEMON Manuals