Speedometer Resistance (Land Cruiser, Sequoia & Tundra)
Remove instrument cluster. See INSTRUMENT CLUSTER under REMOVAL & INSTALLATION. Using an ohmmeter, check resistance between speedometer terminals on rear of instrument cluster. See Figure, Figure and Fig 1 . See SPEEDOMETER RESISTANCE table. If resistance is not as specified, replace speedometer.
SPEEDOMETER RESISTANCE
| Application | Ohms | |
|---|---|---|
| Land Cruiser & Tundra | ||
| Terminals A & B | 160 | |
| Terminals C & D | 160 | |
| Sequoia | ||
| Terminals A & D | 250 | |
| Terminals B & C | 250 | |