LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 97 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P0136: Heated Oxygen Sensor Circuit Fault (Bank 1 Sensor 2) >> Circuit Description

Circuit Description

WARNING: This page is about a different car, the 2003 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.

Heated oxygen sensor monitors exhaust gas oxygen content and delivers an input signal to ECM. ECM uses input signal to determine fuel injection system operation. Heated oxygen sensors include a heater. DTC is set when bank No. 1, sensor No. 2 voltage remains at .4 volt or more, or .6 volt or less during vehicle operation (31 MPH or more), once engine is at normal operating temperature. Possible causes are: