Setting Functions

WARNING: This page is about a different car, the 2003 Lexus ES 300 and 2002 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: All the doors are automatically locked and unlocked when you release the power door lock switch. This indicates the function is set. If all the doors are not locked and unlocked, the time the switch was held may have been too short or too long. Repeat the entire procedure.

NOTE: If you want to cancel the function, perform the same procedure once again. Each time you perform the procedure, the function is set and cancelled alternately.

Close all the doors.
Turn ignition switch to ON position.
Within 10 seconds after ignition switch is turned to ON position;
- Set Locking Linked With The Shift Position
  
  Push and hold the front of the power door lock switch for 5 seconds with the selector lever in the P position.
- Set Unlocking Linked With The Shift Position
  
  Push and hold the rear of the power door lock switch for 5 seconds with the selector lever in the P position.
- Set Locking Linked With Vehicle Speed
  
  Push and hold the front of the power door lock switch for 5 seconds with the selector lever in any position except P.
- Set Unlocking Linked With Opening The Driver's Door
  
  Push and hold the rear of the power door lock switch for 5 seconds with the selector lever in any position except P.