LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 83 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Side Curtain AIR Bag Module

Side Curtain AIR Bag Module

WARNING: This page is about a different car, the 2002 Lexus ES 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure there are no loose components in vehicle. If components are loose, remove and deploy air bag(s) using OFF-VEHICLE DEPLOYMENT  procedure.
  2. Remove rear door scuff plate and door opening weatherstrip. Remove rear seat cushion and seat back. Disconnect side curtain air bag module harness connector. Connect Deployment Tool (09082-00700) and Adapter (09082-00801) to side curtain air bag module connector. Position deployment tool at least 33 feet (10 m) from front of vehicle. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal.
  3. Ensure no one is inside vehicle or within 33 feet of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed
scientia non olet · About LEMON Manuals