LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Head Impact AIR Bag Module

Head Impact AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL . Access and disconnect head impact air bag module connector located behind rear quarter trim panel. See HEAD IMPACT AIR BAG MODULE  under REMOVAL & INSTALLATION.
  2. Connect deployment tool, using Deployment Tool Sub-Harness Adapter 09082-00801, to head impact air bag module connector. Position deployment tool at least 33 feet from front of vehicle. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal.
  3. Ensure no one is inside vehicle or within 33 feet of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
scientia non olet · About LEMON Manuals