LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Air Bag Restraint Systems) >> Disposal Procedures >> Off-Vehicle Deployment >> Head Impact AIR Bag Module

Head Impact AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL . Remove head impact air bag module. See HEAD IMPACT AIR BAG MODULE  under REMOVAL & INSTALLATION.
  2. Cut deployment section (bag material) of air bag module from inflator. Pass strong wire through air bag module mounting holes. Position head impact air bag module inside a scrap tire with air bag deployment direction facing inside. See Figure. Secure head impact air bag module to tire with wire. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire.
  3. Connect deployment tool, using Deployment Tool Sub-Harness Adapter (09082-00801), to head impact air bag module connector. Position deployment tool at least 33 feet away from head impact air bag. Press activation switch to deploy head impact air bag. Because of heat, wait 30 minutes before handling head impact air bag. Seal deployed air bag module in vinyl bag and dispose of in usual manner.
scientia non olet · About LEMON Manuals