LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Side AIR Bag Module

Side AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disconnect negative battery cable. Ensure seat back is not loose. If components are loose, remove and deploy air bag(s) using OFF-VEHICLE DEPLOYMENT  procedure. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL . Disconnect appropriate side air bag module connector, located under seat.
  2. Connect deployment tool, using Deployment Tool Sub-Harness Adapter (09082-00750) to appropriate air bag connector. Position deployment tool at least 33 feet from front of vehicle. Close all doors and windows of vehicle. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal.
  3. Ensure no one is inside vehicle or within 33 feet of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
scientia non olet · About LEMON Manuals