LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 79 (Air Bag Restraint Systems) >> Disposal Procedures >> Off-Vehicle Deployment >> Passenger-side AIR Bag Module

Passenger-side AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL . Remove passenger-side air bag module. See PASSENGER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION.
  2. Position passenger-side air bag module inside a scrap tire with air bag trim cover facing inside. See Fig 1. Secure passenger-side air bag module to tire with wire. Place this tire between 4 other tires (top tire should have wheel installed). Securely tie all tires together with wire.
  3. Connect deployment tool, using Deployment Tool Sub-Harness Adapter (09082-00760), to passenger-side air bag connector. Position deployment tool at least 33 feet away from passenger-side air bag. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Press activation switch to deploy passenger-side air bag. Because of heat, wait 30 minutes before handling passenger-side air bag. Seal deployed air bag module in vinyl bag and dispose of in usual manner.
Fig 1: Preparing Passenger-side Air Bag Module For Deployment
G98H08194Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals