Removal & Installation (Manual Seat)

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Turn ignition switch to LOCK position. Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove seat track covers and 4 mounting bolts. See Fig 1. Disconnect side air bag module electrical connector. Remove front seat.
Remove headrest. Remove 2 retaining screws and seat cushion shield. Remove 2 retaining screws and inner seat cushion shield. Remove front seat cushion inner shield. Remove hog rings, 4 mounting bolts and seat back assembly. Be careful not to damage wire harness.
To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM.

Fig 1: Exploded View Of Front Seat (Power Adjuster Shown; Manual Adjuster Is Similar)