LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Side AIR Bag Module

Side AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure seat back is not loose. If components are loose, remove loose components and deploy using OFF-VEHICLE DEPLOYMENT  procedure. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL .
  2. Disconnect appropriate side air bag Yellow connector, located under seat. Connect deployment tool, using Deployment Tool Sub-Harness Adapter (09082-00750), to appropriate air bag connector. Position deployment tool at least 33 feet (10 meters) from front of vehicle. Close all vehicle doors and windows. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal of 12 volt battery.
  3. Ensure no one is inside vehicle or within 33 feet (10 meters) of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with deployed air bag(s) installed.
scientia non olet · About LEMON Manuals