LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 78 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Driver-side & Passenger-side AIR Bag Module

Driver-side & Passenger-side AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Avalon. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure steering wheel, driver-side air bag and passenger-side air bag modules are not loose. If components are loose, remove loose components and deploy using OFF-VEHICLE DEPLOYMENT  procedure. Test Deployment Tool (09082-00700). See TESTING DEPLOYMENT TOOL .
  2. If deploying driver-side air bag module, remove steering column lower cover and disconnect lower spiral cable connector. If deploying passenger-side air bag, disconnect Yellow passenger-side air bag module connector, accessible through glove box door finish plate.
  3. For driver-side air bag, connect deployment tool to air bag module side of lower spiral cable connector. For passenger-side air bag, connect deployment tool, using Deployment Tool Sub-Harness Adapter (09082-00760), to air bag connector. On both modules, position deployment tool at least 33 feet (10 meters) from front of vehicle. Close all vehicle doors and windows.
  4. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal of 12 volt battery. Ensure no one is inside vehicle or within 33 feet (10 meters) of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with deployed air bag(s) installed.
scientia non olet · About LEMON Manuals