Removal & Installation

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE .
Remove steering wheel. See STEERING WHEEL . Remove lower and upper steering column covers. Disconnect spiral cable connector. Remove 4 screws and spiral cable.
To install, reverse removal procedure. Before installing spiral cable, ensure front wheels are in straight-ahead position and spiral cable is properly aligned. See SPIRAL CABLE under ADJUSTMENTS. Tighten steering wheel nut and driver-side air bag module screws to specification. See TORQUE SPECIFICATIONS . Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .