Removal & Installation

WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable Toyota Hybrid System (THS) if necessary. See DISABLING & ACTIVATING TOYOTA HYBRID SYSTEM (THS) . Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds.
Using screwdriver, remove front door inside scuff plate. Remove front and rear door opening trim. Using screwdriver, remove rear door inside scuff plate. Remove center pillar lower garnish. Remove shoulder and lower seat belt anchor covers, then remove bolts and anchors. Disconnect pretensioner connector. Remove 2 bolts and pretensioner assembly.
To install, reverse removal procedure. Tighten fasteners to specification. See TORQUE SPECIFICATIONS . Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .