LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC 61/B0132: Short To Ground In Passenger-Side Seat Belt PRETENSIONER Squib Circuit >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Measure resistance between ground and Yellow/Black wire (circuit PR+) of air bag sensor assembly side of right seat belt pretensioner squib harness connector. See WIRING DIAGRAMS . If resistance is less than one megohm, repair or replace harness or connector between passenger-side seat belt pretensioner and air bag sensor assembly. If resistance is more than one megohm, go to next step.
  3. Reconnect air bag sensor assembly connector A19 (right connector) to air bag sensor assembly. Connect jumper wire between passenger-side seat belt pretensioner squib harness connector Yellow/Black wire (circuit PR+) and Yellow wire (circuit PR-). Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 61/B0132 is not displayed, go to next step. If DTC 61/B0132 is displayed, replace air bag sensor assembly.
  4. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect passenger-side seat belt pretensioner squib harness connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 61/B0132 is not displayed, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT . If DTC 61/B0132 is displayed, replace passenger-side seat belt pretensioner.