LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Air Bag Restraint Systems) >> Diagnostic Tests >> Air Bag Warning Light Does Not Illuminate >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove AM2 fuse and check continuity across fuse blades. AM2 fuse is located in left engine compartment fuse block. If fuse is faulty, replace fuse and go to step  3. If fuse is okay, reinstall fuse and go to next step.
  2. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Reconnect negative battery cable. Turn ignition switch to ON position. Measure voltage between ground and air bag sensor assembly connector A18, terminal No. 3 (circuit LA, Black/Yellow wire). See Fig 1. If 10-14 volts is not present, repair AIR BAG warning light bulb or circuit. If 10-14 volts is present, replace air bag sensor assembly.
  3. Recheck AM2 fuse. If fuse is blown, check harness between AM2 fuse and AIR BAG warning light. If fuse is okay, check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT .
Fig 1: Identifying Air Bag Sensor Assembly Connectors
G99A23556Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002