Removal & Installation
WARNING: This page is about a different car, the 2002 Toyota Celica. However, it is still accessible from the selected car via links, so may be relevant.
- Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove 3 screws, 2 bolts and lower finish panel (glove box assembly). See Fig 1. Remove connector cover from lower finish panel and disconnect Yellow passenger-side air bag module connector. See Figure. Remove bolt and 2 nuts and passenger-side air bag module.
- To install, reverse removal procedure. Tighten air bag module retaining bolt to specifications. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM under DISABLING & ACTIVATING AIR BAG SYSTEM. Check the AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK .