LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Air Bag Restraint Systems) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicles Only) >> Driver-side & Passenger-side AIR Bag Module

Driver-side & Passenger-side AIR Bag Module

WARNING: This page is about a different car, the 2002 Toyota Celica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure steering wheel, driver-side air bag and passenger-side air bag modules are not loose. If components are loose, remove and deploy air bag(s) using OFF-VEHICLE DEPLOYMENT  procedure.
  2. If deploying driver-side air bag module, disconnect Yellow spiral cable connector under steering column. If deploying passenger-side air bag, disconnect Yellow passenger-side air bag connector, accessible by removing lower finish panel (glove box assembly). See Figure.
  3. For driver-side air bag, connect Deployment Tools (09082-00700 and 09082-00760) to air bag module connector. For passenger-side air bag, connect Deployment Tools (09082-00700 and 09082-00760) to air bag module connector. On both modules, position deployment tool at least 33 feet from front of vehicle. Close all doors and windows of vehicle.
  4. Connect deployment tool Red clip to positive battery terminal and Black clip to negative battery terminal. Ensure no one is inside vehicle or within 33 feet of vehicle. Press activation switch to deploy air bag. Because of heat, DO NOT touch air bag for at least 30 minutes after deployment. Scrap vehicle with air bag(s) still installed.
scientia non olet · About LEMON Manuals