LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Air Bag Restraint Systems) >> Disabling & Activating Air Bag System >> Disabling System >> For Diagnostics

For Diagnostics

WARNING: This page is about a different car, the 2002 Toyota Celica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch to LOCK position. Disconnect and shield negative battery cable. Wait at least 90 seconds. Remove driver-side air bag module. See DRIVER-SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Disconnect passenger-side air bag module connector, accessible by removing lower finish panel (glove box assembly). See Fig 1. Disconnect air bag sensor assembly connectors. See AIR BAG SENSOR ASSEMBLY  under REMOVAL & INSTALLATION.
  2. Disconnect right and left front air bag sensor connectors. See FRONT AIR BAG SENSORS  under REMOVAL & INSTALLATION. Disconnect right and left seat belt pretensioner connectors. See SEAT BELT PRETENSIONER  under REMOVAL & INSTALLATION. Disconnect right-side and left-side air bag module connectors. See SIDE AIR BAG MODULE  under REMOVAL & INSTALLATION. Disconnect right and left-side air bag sensor connectors. See SIDE AIR BAG SENSOR  under REMOVAL & INSTALLATION. Disconnect right and left door side air bag sensor connectors. See DOOR SIDE AIR BAG SENSOR  under REMOVAL & INSTALLATION.
Fig 1: Disconnecting Passenger-side Air Bag Module Connector
G99G20509Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals