LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC 44/B0111: Open In Right-Side Air Bag Module Squib Circuit >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2002 Toyota Celica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Measure resistance between Yellow/Red wire (circuit SFR+) and Yellow/Green wire (circuit SFR-) of right-side air bag squib harness connector. See WIRING DIAGRAMS . If resistance is less than one ohm, go to next step. If resistance is more than one ohm, repair or replace harness or connector between right-side air bag squib harness connector and air bag sensor assembly.
  3. Reconnect air bag sensor assembly connector C8 to air bag sensor assembly. See Figure. Connect jumper wire between Yellow/Red wire (circuit SFR+) and Yellow/Green wire (circuit SFR-) of right-side air bag squib harness connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 44/B0111 is not displayed, go to next step. If DTC 44/B0111 is displayed, replace air bag sensor assembly.
  4. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect right-side air bag module connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 44/B0111 is not displayed, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT . If DTC 44/B0111 is displayed, replace side air bag module.
scientia non olet · About LEMON Manuals