LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Transfer Case Diagnosis -VF2BM) >> Removal & Installation >> L4 Position Switch >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2002 Toyota Tundra and 2001 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect electrical connector from L4 position switch located on transfer case. Unscrew L4 position switch from transfer case. Remove gasket from L4 position switch and discard.
  2. To install, reverse removal procedure using NEW gasket. Tighten L4 position switch to specification. See TORQUE SPECIFICATIONS . Reinstall electrical connector.
scientia non olet · About LEMON Manuals