Transfer Shift Actuator Resistance

WARNING: This page is about a different car, the 2002 Toyota Tundra and 2001 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: For circuit reference, see CONNECTOR IDENTIFICATION and/or WIRING DIAGRAMS .

Using an ohmmeter, measure the resistance between terminals No. 1 and 2. See Figure. Resistance should be .3-100 ohms. Measure the resistance from terminals No. 1 and 2 to ground. Resistance should be more than .5 Mega ohms. If resistance is not as specified, replace the actuator assembly.