Park/Neutral Position Switch: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sequoia, 2002 Toyota 4Runner, and 2001 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

Install switch on control shaft. Loosely install switch retaining bolts. Install seal and lock washer. Install lock nut and tighten to specification. See TORQUE SPECIFICATIONS . Bend tabs on lock washer over against lock nut.
Ensure parking brake is applied. Temporarily install manual lever on control shaft. Place gearshift lever in Neutral position. Remove manual lever. Rotate park/neutral position switch and align neutral basic line on PNP switch with groove. See Fig 1 or Fig 2 .
Hold PNP switch in this position. Tighten retaining bolts to specification. To install remaining components, reverse removal procedure.

Fig 1: Removing & Installing PNP Switch (Except Tundra)

Fig 2: Removing & Installing PNP Switch (Tundra)