Park/Neutral Position Switch: Installation
WARNING: This page is about a different car, the 2002 Toyota Land Cruiser, 2002 Lexus LX 470, 2001 Toyota Land Cruiser, and 2001 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
- Install switch on control shaft. Loosely install switch retaining bolts. Install seal and lock washer. Install lock nut and tighten to specification. See TORQUE SPECIFICATIONS . Bend tabs on lock washer over against lock nut.
- Ensure parking brake is applied. Temporarily install manual lever on control shaft. Place gearshift lever in Neutral. Remove manual lever. Rotate park/neutral position switch and align neutral base line on PNP switch with groove. See Fig 1.
- Hold PNP switch in this position. Tighten retaining bolt to specification. See TORQUE SPECIFICATIONS . To install remaining components, reverse removal procedure.