LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Automatic Transmission Diagnosis - U241E) >> Removal & Installation >> Park/Neutral Position Switch >> Removal

Park/Neutral Position Switch: Removal

WARNING: This page is about a different car, the 2003 Toyota RAV4, 2002 Toyota RAV4, 2002 Toyota Highlander, 2001 Toyota RAV4, and 2001 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Park/Neutral Position (PNP) switch is located on side of transaxle. Disconnect switch connector. Remove shift control nut and cable from manual lever. Remove lock nut, washer and manual lever from control shaft. See Figure.
  2. Bend up tabs on lock washer. Remove lock nut, lock washer and seal from control shaft. Remove adjusting bolts and PNP switch.
scientia non olet · About LEMON Manuals