Removal & Installation (Celica)
WARNING: This page does not describe the selected car, but rather 15 other vehicles, including the 2002 Toyota Tundra, 2002 Toyota Tacoma, 2002 Toyota Sienna, 2002 Toyota Sequoia, and 2002 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect negative battery cable. Disconnect air intake temperature sensor connector from air cleaner assembly. If equipped, remove cruise control actuator cable from clamps.
- On California models, remove air hose for idle-up from air cleaner hose. On all models, disconnect 4 clamps, and disconnect air cleaner cap from air cleaner case. Loosen hose clamp, and disconnect air cleaner hose from throttle body.
- Remove air cleaner cap and air cleaner hose assembly. Remove air filter. Disconnect 2 engine wires from clamps on air cleaner case. Remove 3 bolts and air cleaner case. Remove battery. If equipped with cruise control, disconnect cruise control actuator connector.
- Remove 3 bolts, and disconnect actuator from body bracket. On all models, disconnect starter connector. Remove nut, and disconnect starter cable. Remove 2 bolts, and disconnect oxygen sensor connector and engine wire brackets from starter. Remove starter. To install, reverse removal procedure. Tighten starter bolts to specification. See TORQUE SPECIFICATIONS .