LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Removal & Installation >> Vacuum Brake Booster >> Installation (ES 300)

Installation (ES 300)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a NEW gasket to vacuum brake booster and Install brake booster assembly. Tighten nuts to specification. See TORQUE SPECIFICATIONS .
  2. Install front brake tube No. 5 with special tool (09023-00100) and tighten to specification. See TORQUE SPECIFICATIONS .
  3. Install push rod clevis and lock nut.
  4. Apply lithium soap base glycol grease and install push rod pin and clip.
  5. Install instrument panel components and front door scuff plate.
  6. Install vacuum hose line to body with bolt and tighten to specification. See TORQUE SPECIFICATIONS . Connect vacuum hose to vacuum brake booster with clip.
  7. Install charcoal canister assembly with bolts and tighten to specification. See TORQUE SPECIFICATIONS .
  8. Install master cylinder. See MASTER CYLINDER .
  9. Fill reservoir with brake fluid and bleed brake system. See BLEEDING BRAKE SYSTEM . Check for fluid leakage. Ensure brake pedal height is correct. See BRAKE PEDAL HEIGHT & FREE PLAY  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals