LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Removal & Installation >> Rear Brake Caliper >> Removal & Installation (LS 430)

Removal & Installation (LS 430)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear wheel.
  2. Remove clip, pin and anti-rattle spring. See Figure.
  3. Remove 2 pads with anti-squeal shims. Do not disconnect pad wear indicator assembly unless pads are to be replaced.
  4. Remove union bolt and gasket from caliper. Disconnect brake hose from caliper. Use a container to catch brake fluid as it drains out.
  5. Remove 2 bolts and caliper from knuckle.
  6. To install, use 2 new bolts. Since the screwed part is an aluminum knuckle, carefully clean any foreign matter on screwed surface. Do not over tighten fasteners. Pull caliper toward outside of vehicle to remove play between pin and knuckle hole. Tighten bolts starting with lower bolt. Observe the correct order and tighten only to specification. See TORQUE SPECIFICATIONS .
  7. Install flexible hose lock securely in lock hole in caliper.
  8. Install new gaskets and tighten union bolt to specification. See TORQUE SPECIFICATIONS .
  9. Tighten wheel lug nut to specification. See TORQUE SPECIFICATIONS .
  10. Fill brake reservoir with brake fluid and bleed brake system. See BLEEDING BRAKE SYSTEM .
  11. Check system for leaks.
scientia non olet · About LEMON Manuals