Installation (LS 430)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Apply high temperature grease to anchor block, adjuster, and contact points of rear axle carrier. See Figure.
- Adjust parking brake shoe clearance. See PARKING BRAKE SHOE CLEARANCE under ADJUSTMENTS.
- Tighten anchor block nuts to specification. See TORQUE SPECIFICATIONS .
- When installing parking brake shoe lever, be careful to install correct lever for each side.
- Seat parking brake shoes and disc. See SEATING PARKING BRAKE SHOES AND DISC under ADJUSTMENTS.
- Adjust parking brake pedal. See PARKING BRAKE under ADJUSTMENTS.
PARKING BRAKE SPECIFICATIONS
| Application | In. (mm) | ||
|---|---|---|---|
| ES 300 & RX 300 | |||
| Brake Shoe Thickness | |||
| Standard | .079 (2.0) | ||
| Minimum | .039 (1.0) | ||
| Brake Drum Inside Diameter | |||
| Standard | 6.69 (170) | ||
| Maximum | 6.73 (171) | ||
| GS 300 & GS 430 | |||
| Brake Shoe Thickness | |||
| Standard | .098 (2.5) | ||
| Minimum | .039 (1.0) | ||
| Brake Drum Inside Diameter | |||
| Standard | 7.48 (190) | ||
| Maximum | 7.52 (191) | ||
| Parking Brake Shoe & Lever Clearance | |||
| Standard | .0138 (.35) | ||
| IS 300 | |||
| Brake Shoe Thickness | |||
| Standard | .098 (2.5) | ||
| Minimum | .039 (1.0) | ||
| Brake Drum Inside Diameter | |||
| Standard | 7.48 (190) | ||
| Minimum | 7.52 (191) | ||
| LS 430 | |||
| Brake Shoe Thickness | |||
| Standard | .138 (3.5) | ||
| Minimum | .039 (1.0) | ||
| Brake Drum Inside Diameter | |||
| Standard | 7.48 (190) | ||
| Maximum | 7.52 (191) | ||
| LX 470 | |||
| Brake Shoe Thickness | |||
| Standard | .157 (4.0) | ||
| Minimum | .039 (1.0) | ||
| Brake Drum Inside Diameter | |||
| Standard | 9.06 (230) | ||
| Maximum | 9.09 (231) | ||
| SC 430 | |||
| Brake Shoe Thickness | |||
| Standard | .098 (2.5) | ||
| Minimum | .039 (1.0) | ||
| Brake Drum Inside Diameter | |||
| Standard | 7.48 (190) | ||
| Maximum | 7.52 (191) | ||