LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Removal & Installation >> Master Cylinder >> Removal & Installation (IS 300)

Removal & Installation (IS 300)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove brake fluid.
  2. Disconnect brake fluid level switch harness connector.
  3. Using special tool (09023-00100) disconnect brake lines.
  4. Disconnect brake hoses. Remove nuts and pull out check valve bracket, brake hose clamp, master cylinder and gasket.
  5. To install, reverse removal procedure. Tighten installation nuts and brake lines to specification. See TORQUE SPECIFICATIONS .
  6. Adjust length of brake booster push rod. See POWER BRAKE UNIT PUSH ROD  under ADJUSTMENTS.
  7. Fill brake reservoir and bleed brake system. See BLEEDING BRAKE SYSTEM .
  8. Check system for leaks.
  9. Check and adjust brake pedal. See BRAKE PEDAL HEIGHT & FREE PLAY  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals