LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Removal & Installation >> Master Cylinder >> Installation (RX 300)

Installation (RX 300)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Adjust length of brake booster push rod. See POWER BRAKE UNIT PUSH ROD .
  2. To install, reverse removal procedure. Tighten nuts holding master cylinder, gasket and bracket to specification. See TORQUE SPECIFICATIONS .
  3. Match paint lines on brake hoses and tighten to specification. See TORQUE SPECIFICATIONS .
  4. Tighten reservoir assembly bolt to specification. See TORQUE SPECIFICATIONS .
  5. Install reservoir hoses in line with paint marks.
  6. Fill brake reservoir with brake fluid and bleed brake system. See BLEEDING BRAKE SYSTEM .
  7. Check system for leaks and check and adjust brake pedal. See BRAKE PEDAL HEIGHT & FREE PLAY .
scientia non olet · About LEMON Manuals