LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Overhaul >> Rear Caliper >> Disassembly & Assembly (RX 300)

Disassembly & Assembly (RX 300)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear caliper. See REAR BRAKE CALIPER  under REMOVAL & INSTALLATION.
  2. Remove sliding bushing, dust boots and main pin boot.
  3. Using a screwdriver, remove boot ring and piston boot.
  4. Put a piece of cloth between piston and caliper.
    WARNING: Do not place your fingers in front of piston when using compressed air.
  5. Use compressed air to remove piston from cylinder.
  6. Using a screwdriver, remove piston seal.
  7. Remove sliding pins from torque plate. Remove sliding bushing from upper side of sliding pin. Using a screwdriver and hammer, tap out dust boots.
  8. To assemble, reverse disassembly procedure. Ensure that boots are secured firmly to bushing and caliper grooves.
scientia non olet · About LEMON Manuals