LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Overhaul >> Rear Caliper >> Disassembly & Assembly (LX 470)

Disassembly & Assembly (LX 470)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove rear caliper. See REAR BRAKE CALIPER  under REMOVAL & INSTALLATION.
  2. Using a screwdriver, remove cylinder boot from caliper.
    3. WARNING: Do not place your fingers in front of piston when using compressed air.
  3. Place a piece of cloth or a similar object between piston and caliper. Use compressed air to remove piston from cylinder.
  4. Using a screwdriver, remove piston seals from caliper.
  5. Using a screwdriver with a taped tip and hammer, tap out pin boot and sliding bushing.
  6. To assemble, reverse disassembly procedure. Apply lithium soap base glycol grease to sliding pins, boots and piston seals.
  7. Install rear caliper. See REAR BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals