Assembly (GS 300 & GS 430)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
- To install accumulator bracket, adjust clearances "A", "B", "D" and "E". Using thickness gauge, ensure clearances correspond to each value and are within a range of .004-.016" (.1-.4 mm). See Fig 1 and Fig 2 .
- To complete assembly, reverse disassembly procedure. Tighten accumulator, brake actuator No. 1 tube, oil pressure sensor, caliper boot and reservoir screws to specification. See TORQUE SPECIFICATIONS .
- Install hydraulic brake booster. See POWER BRAKE UNIT under REMOVAL & INSTALLATION.
After installation, fill brake reservoir with brake fluid. Bleed brake system and check system for leaks. See BLEEDING BRAKE SYSTEM .