LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Disc Brakes) >> Overhaul >> Front Caliper >> Assembly (ES 300)

Assembly (ES 300)

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 Lexus SC 430, 2002 Lexus RX 300, 2002 Lexus LX 470, 2002 Lexus LS 430, and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Temporarily tighten bleeder screw to disc brake caliper.
  2. Install front disc brake bleeder screw cap.
  3. Apply lithium soap base glycol grease to new piston seal(s). Install piston seal(s) to disc brake caliper.
    4. NOTE: Do not screw piston forcibly into disc brake caliper.
  4. Apply lithium soap base glycol grease to piston(s) and install piston(s) to disc brake caliper.
  5. Apply lithium soap base glycol grease to NEW caliper boot(s). Install caliper boot(s) securely to grooves of caliper and piston(s).
  6. Using a screwdriver, install new set ring(s). Do not damage caliper boot.
  7. Place front disc brake caliper mounting in vise. Apply lithium soap base glycol grease to seal surface of 2 new bush dust boots. Using a socket wrench (19 mm) and hammer, drive brake bush dust boots into brake caliper mounting.
  8. Install front disc brake caliper mounting. See FRONT BRAKE CALIPER  under REMOVAL & INSTALLATION.
scientia non olet · About LEMON Manuals