LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Manual A/C-Heater Systems) >> Compressor And Magnetic Clutch >> Removal

Compressor And Magnetic Clutch: Removal

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Run engine at idle speed with A/C on for approx. 10 minutes.
  2. Stop engine.
  3. Disconnect negative (-) terminal cable from battery.
  4. Discharge refrigerant from refrigeration system.
  5. 5VZ-FE engine: Remove engine under cover.
  6. 5VZ-FE engine: Disconnect discharge and suction hoses.

    Remove the 2 bolts and disconnect the both hoses.

    NOTE: Cap the open fitting immediately to keep moisture or dirt out of the system.
  7. 2UZ-FE engine: Disconnect discharge and suction hoses.

    Remove the 2 nuts and disconnect the both hoses.

    NOTE: Cap the open fitting immediately to keep moisture or dirt out of the system.
  8. Remove drive belt. See REMOVAL .
  9. 5VZ-FE engine: Remove compressor.
    1. Disconnect the connector.
    2. Remove the 4 bolts and compressor.
  10. 2UZ-FE engine: Remove compressor.
    1. Disconnect the connector.
    2. Remove the 4 bolts and nut.
    3. Remove the cooler bracket.
    4. Remove the compressor.
scientia non olet · About LEMON Manuals