LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Manual A/C-Heater Systems) >> Blower Unit >> Removal

Blower Unit: Removal

WARNING: This page is about a different car, the 2002 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove cooling unit. See step  10 under COOLING UNIT REMOVAL.
  2. Remove blower unit.
    1. Disconnect the connector from the blower motor.
    2. Disconnect the air inlet damper control cable from the blower unit.
      NOTE: At the time of installation, please refer to the following item:

      After connection, adjust the control cable.

    3. Remove the nut, bolt and blower unit.
scientia non olet · About LEMON Manuals