LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 470 (Rear Left Door Control System - Diagnosis) >> Circuit Inspection >> DTC B1238 Jam Protection Pulse Switch Circuit on Rear Left Door >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

In case of not using the LEXUS hand-held tester, start from step3.

  1. Whether or not this DTC is cleared when the power window is moved from fully-closed to fully-opened condition. 
    1. YES : It is suspected that the DTC was detected by ECU with any failure in the past. 
    2. NO : Go to next step. 
  2. Check jam protection pulse switch (See  INSPECTION  ). 
    1. NG : Replace the power window motor. 
    2. OK : Go to next step. 
  3. Check wire harness and connector between jam protection pulse switch and rear door LH ECU. (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ) 
    1. NG : Repair or replace wire harness or connector. 
    2. OK : Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
scientia non olet · About LEMON Manuals